1. Hold the MIN button down until the hour starts flashing.
2. Use the SEC button to adjust the hour.
3. Press the MIN button to switch to minutes.
4. Use the SEC button to adjust the minutes.
5. Press the MIN button to exit.
Answer by: Westlab on 14 Jan 2025, 5:43 am
I have purchased one of these timers and would like a manual for it.
Question by: Ian on 29 Oct 2024, 7:30 am
Countdown and normal count-up settings:
• Press the ‘MINUTE’ key to set the required minute value
• Press the ‘SECOND’ key to set the required second value
• Press the ‘START/STOP’ key to begin the countdown, the alarm will occur when the countdown hits zero
• Double press the ‘RESET’ key to stop the countdown and to display zero
• Double press the ‘START/STOP’ key to begin normal count-up, then press the ‘START/STOP’ key again for time-out. Next, press the ‘RESET’ key to display a zero value.
Counting
• Press the ‘RESET’ key to clear the values, or synchronously press the ‘MINUTE’ key and the ‘SECOND’ key to display a zero value
• Press the ‘START/STOP’ key to begin the count-up
• Double press the ‘START/STOP’ key to stop the count-up. To add the values, press the ‘START/STOP’ key again.
Battery installation
• When the display is not clear, you will need the change the batteries.
• Open the cover of the battery container and place 2 x AAA 3V alkaline batteries in.
1. Hold the MIN button down until the hour starts flashing.
2. Use the SEC button to adjust the hour.
3. Press the MIN button to switch to minutes.
4. Use the SEC button to adjust the minutes.
5. Press the MIN button to exit.
Answer by: Westlab on 14 Jan 2025, 5:43 am
I have purchased one of these timers and would like a manual for it.
Question by: Ian on 29 Oct 2024, 7:30 am
Countdown and normal count-up settings:
• Press the ‘MINUTE’ key to set the required minute value
• Press the ‘SECOND’ key to set the required second value
• Press the ‘START/STOP’ key to begin the countdown, the alarm will occur when the countdown hits zero
• Double press the ‘RESET’ key to stop the countdown and to display zero
• Double press the ‘START/STOP’ key to begin normal count-up, then press the ‘START/STOP’ key again for time-out. Next, press the ‘RESET’ key to display a zero value.
Counting
• Press the ‘RESET’ key to clear the values, or synchronously press the ‘MINUTE’ key and the ‘SECOND’ key to display a zero value
• Press the ‘START/STOP’ key to begin the count-up
• Double press the ‘START/STOP’ key to stop the count-up. To add the values, press the ‘START/STOP’ key again.
Battery installation
• When the display is not clear, you will need the change the batteries.
• Open the cover of the battery container and place 2 x AAA 3V alkaline batteries in.